https://www.rc-wintrans.com/forum_srv/messages.aspx?TopicID=197 RC-WinTrans - RC-WinTrans Support - "Error: Failed to remove Unicode BOM from file" - Messages en-us http://blogs.law.harvard.edu/tech/rss Jitbit AspNetForum Tue, 10 Jun 2014 08:47:07 GMT Tue, 10 Jun 2014 08:47:07 GMT https://www.rc-wintrans.com/forum_srv/messages.aspx?TopicID=197 Tue, 10 Jun 2014 08:47:07 GMT https://www.rc-wintrans.com/forum_srv/messages.aspx?TopicID=197 An additional Byte is added to the end of the file when writing a target file without BOM.

We will fix this.

Regards,
Support, Schaudin.com]]> Mon, 09 Jun 2014 22:34:40 GMT https://www.rc-wintrans.com/forum_srv/messages.aspx?TopicID=197 Thanks for the quick answer
However, the built file is not valid.
The BOM is moved at the end of file
I sent you by email the files, generated by RCW 9.3 and 9.4.
Regards,]]> Mon, 09 Jun 2014 09:20:31 GMT https://www.rc-wintrans.com/forum_srv/messages.aspx?TopicID=197
this error message is always prompted to the output tab when writing a file without BOM.
It is a fault but the target file is created correctly without BOM.
You can ignore this error message.

It will be fixed in the next release (next to the current RC-WinTrans 9.4.0.76/April 2014).

Thank you for posting this error.

Regards,
Support, Schaudin.com]]> Sun, 08 Jun 2014 19:23:58 GMT https://www.rc-wintrans.com/forum_srv/messages.aspx?TopicID=197 In the RCWintrans 9.4, we can choose to write an Unicode file without BOM.
This is great as many properties files must be generated without BOM.
Until the v9.4, I had to do a post process, removing BOM.
However, when I tried this new feature (UTF-8 no BOM), I got the following message in the output pane "Error: Failed to remove Unicode BOM from file", and the generated file was not valid.

Screen Capture

Regards,
JM
edited by jmv on 06.06.2014
edited by jmv on 06.06.2014
edited by jmv on 06.06.2014]]> Fri, 06 Jun 2014 10:42:57 GMT